Part 4 - Print inner layers
112 بار بازدید -
6 سال پیش
-
To produce the inner layers
To produce the inner layers of our multilayer PCB, we start with a panel of laminate. Laminate is an epoxy resin and glass-fibre core with copper foil pre-bonded onto each side.
The first step is to clean the copper.
We print the panels in a clean room to make sure that no dust gets onto the surface where it could cause a short or open circuit on the finished PCB.
6 سال پیش
در تاریخ 1397/07/13 منتشر شده
است.
112
بـار بازدید شده