Milling on the Lathe

Don't Forget To - LIKE | SUBSCRIBE | SHARE Recently I purchaced from ebay a dremel holder that can be attached to the toolpost of a lathe. The problem was that the shank was too thick for my lathe, and as a result the center of the lathe's chuck, wasn't at the same height as the dremel's chuck was. One way, was to sand it down to the desired thickness, but then I remembered that I had an 8mm end mill cutter that could do the job on my lathe. I did it twice because I had to flip it over

• #فناوری_و_رایانه
• #woodturning
• #milling_product_category
• #lathe_invention